HTMC-7 DIY Mini Incubator with Temperature Control Automatic Egg Turner Digital 220V

Features:1.We provide you with a complete set of incubation accessories, you only need to prepare a box.2.When the dual power cord is powered off, it can be connected to a 12V battery for safe incubation3.Exhaust fan makes heat dissipation uniform, low noise, long use time, chip panel, one?key incubation control.4.The home incubator motor has two working modes: forward rotation and reverse rotation.5.Heating film, constant temperature PTC heating, the incubation temperature is guaranteed.6.Humidity probe, digital probe, stable performance, accurate temperature sensor, accurate collection of information.Specification:Item Type: DIY Mini IncubatorMaterial: ABS+AluminumRated Power: 80WMotor Voltage: 12VMotor Power: Maximum 4WMotor Working Mode: Forward/ReverseEgg Turning Frequency: Every 2h/TimeTemperature Control Range: 37-39Scope of Application: 48 Pieces/56 Pieces/96 Pieces/112 PiecesPackageList:1 x Panel1 x Motor1 x Exhaust Fan1 x Heating Film1 x Humidity Probe1 x Temperature Probe1 x Motor Link Line1 x Plug1 x 12V Power Cable1 x Manual12 x Screw8 x Nut8 x Gasket8 x Insulation ColumnNote1. The incubator needs to be prepared by yourself, which can be made of wood, acrylic, plastic, or glass. 2. The temperature of the heating plate can up to 270. Please use a gasket to isolate it when connecting and installing3. In the design of the box, it is recommended to make a "sink" in the box to facilitate the addition of water, and the corresponding amount of water can be added according to the required humidity, so that the humidity of each area is within the normal range4. Turning over the egg tray needs another shotInstallation instructions:1, find a box, as an incubator carrierTips: in the process of designing the size of boxes, the size is generally 50 50 35cm(boxes are not limited to these two types, here is an example)2, need to punch holes in the box, install accessoriesIntimate tip: Screw hole position, please take the actual type as the standard (because the panel needs to be connected to the power supply, for safety, please add an inner box)3. The box body is thoroughly drilled for air circulation