For Yamaha Immobiliser Emulator 2002 - 2021 R1 R6 MT07 MT09 MT10 TMAX XMAX++ Report Item / Suspicious Activity Compatible 2002 - 2021 For Yamaha models: YZF R1 / YZF R6 FZ6N / FZ6S XJ6 T-MAX X-MAX V-MAX MT03, MT07, MT09, MT10 MAJESTY 400 XSR700 XSR900 This version has had a redesign with the following: Mechelectrics Custom Firmware - Exclusive firmware allows this to work on the widest range of models Reduced Power Consumption - Less current drawn from battery in standby Higher rated capacitors - No chance of emulator blowing capacitors as with the older designs Dual layered PCB - Reduced corrosion when used in damp / wets Compact Design - No messy long wires 30% Smaller PCB - design has reduced size and weight compared to old versions Water resistant casing - Sealed unit so no water ingress This item is designed for the following purposes: Swap engines which no longer work with existing immobiliser unit (they are paired to engine ECU) Enable users to remove damaged immobiliser units due to theft damage / recovery Enable users to avoid high charges from For Yamaha dealer for replacing matched immobiliser / ECU unit Project bikes using For Yamaha engine / ECU but no immobiliser (track day safety requirements) Fault finding by omitting the immobiliser as source of starting issues This 6 wire version has the highest chance of compatibility as it uses the full manufacturer wiring schematic which also keeps the immobiliser dash LED functioning (varies depending on model). Custom firmware flashed in house by Mechelectics to ensure this is the most widely compatible emulator on the market! If it doesn't work on your For Yamaha model listed below, return for a full refund Fitting Instructions (1) Simply trace your wiring from your key barrel transponder back to your ECU (usually under the fuel tank or headlight) 2) Unplug and plug in the 'Plug and Play' emulator. 3) You can now start your vehicle without transponder in the key