Universal Type 24V PCB Board For Automatic Double Arms Swing Gate Opener Control Board Panel Smart Control Center System Please note , This PCB control board can only use the remote control in our photo, it cannot be used with other remote controls Features 1. Application: Used for double or single swing gate opener. 2. Speed -adjustable function. 3. Auto closing/opening,opening/closing delay time adjustment. 4. Adjustable Residence sensitivity. 5.Terminals available for loop detector, photocell, push button, keypad, access control equipment 6. Digital LED Menu brings a easy setting, plug and play. 7. Open/Close single leaf or double leaves. 8. Total 60's working time to protect the motors. Technical Parameters: 1.Control panel voltage input: 24VDCAC. Can connect 2PCS 12V 9AH back up battery. Note that the control board purchased separately needs to be used with a transformer, and cannot be directly 100-250V AC. 2.Motor's voltage: 12-24VDC support.The input of the control board is 24V, and the output is 12-24V. 3.Encoder for transmitter: Use our own customized rolling code.(Encrypted code, no copying and non-ing of our products ) 4.Range of application: Suit for our double arms swing gate openers. *The Linear Spiral 24V Straight Brush Arm is supported, but only fully works with our products, and is not covered by the warranty if tested on a non-ours product. Functions and testing: 1. MOTOR 1: Master gate, close first & open last.This terminal connect 1st red wire (counted from your left hand side to right hand side) 2. MOTOR2(DELAY) : Slave gate, open first & close last.This terminal connect 1st blue wire (counted from your left hand side to right hand side). NOTE! If you only have a single gate, the motor only can connect to the Motor 2 Delay terminal. 3. 2 SIDE: It is for connecting to any external device that operates a double gate. 4. COM:It is for connecting to the “ ground ”. 5. 1 SIDE: It is for connecting to any external device that operates the single gate. 6. Swipe Card: It is for connecting to any external devices to open the gate. 7. COM:It is for connecting to the “ ground ” external device. 8. IR: Infrared terminal is for connecting to the safety beam. 9. 12V: The output is for connecting to the photocell sensor, continuous output current