No Limits of the car model and year + No Need disassemble ECUs Read and write for ECUs ('s chips) incl. flash and eeprom. Less Risk to clone/copy ECUs to modify data or do chip tuning to achieve superior performance. Much Cheaper, compared with the same functional tools, price is 1/10 of other programming tools in the market. Notice:Please never connect to internet to update or device will get locked. Cover for N20, N55, N63, etc. to change or read/write ISN codes (done with other tools).Cover for MED17.1.1 to read/write immo data.Cover the latest for MED17.8.32 Cover for MED17.5.5, MED17.5.22, MED17.5.25 ... ALL can be done without ECU disassembling Good equipment of high quality and with the technology What is differences between for KTMBENCH ,KTMFLASH and KTMOBD? Bench Boot is the latest ECU programming tool for ECU read and write via Boot mode or on bench. KTMFlash ECU programmer can read the chip data, read & write ECU data. read transmission data etc. at a high speed. KTMOBD programmer was born for reading chip data, reading and writing data of ECUs and a few types of gearbox. Read/write data by OBD.Supports most Japanese cars All programming tools above can be used for ECU read and write, but differs in ECU coverage and Read/Write . There is NO LIMITS of the car model and year when using bench to read/write data. But if you have chips and gearboxes to read and write, you should have a flash. The bad is: disassembling is required. bench doesn't cover chips and gearboxes and OBD cannot not work good for gerabox Read/Write. So, you'd better check the ECU/gearbox/chip before your purchase. Check each car list on corresponding product page. Plug Type: US Plug, it applies to Canada, India, Mexico, Thailand, Taiwan, the , the Philippines and so on. Voltage: AC100-240V Colour:silver Material:plastic Package Contents: 1 x ECU Programmer set Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.