Features Hall-type current conversion withstanding 30 times the nominal input, prevents instantaneous high current access, and enhances sensor durability and longevity. Isolated detection and output signals effectively filter noise, improve signal-to-noise ratio, and enhance anti-interference ability for stable and accurate measurements. Highly insulated and isolated primary and secondary sides bring high accuracy, small size, low power consumption, wide frequency response, and strong anti-interference properties. No insertion loss due to perforated input, easy installation with standard guide rail and flat screws, ensuring convenience and efficiency. Especially suitable for load current intelligent monitoring systems in various industries such as generators, motors, power distribution cabinets, air conditioners, fans, street lamps, and power grid monitoring. Specification: Item Type: AC Current Transmitter Material: ABS Power Supply: DC24V Installation Method: Standard rail + flat screw fixation Product Use: Used to measure AC current, especially for power frequency 50Hz sine wave AC current Rated Current: AC0-100A Rated Output: DC4-20mA Load Capacity: Voltage Output: 5mA; Current Output: 6V Accuracy: 0.5% Overload Capacity: 30 Times the nominal input Isolation withstand Voltage: 3KV/50Hz, 1Min Offset Voltage: ≤10mV Temperature Drift: ≤500PPM/℃ Linearity: 0.1% Frequency Bandwidth: 20-5KHz Current Consumption: between15mA+ output current Response Time: between200ms Working Temperature: -109℃~+70℃ Storage Temperature: 25℃~85℃ Package List: 1 x AC Current Transmitter Note: Please do not use 250ohm or 500ohm to connect 4‑20mA output version of the transmitter to get 0‑5V or 0‑10V, this is a completely wrong method, you cannot get 0‑5V or 0‑10V signal, and it will make transmit becomes overheated or damaged. Package List 1 x AC Current Transmitter