1、Labor Saving Design: The ergonomic clutch rod reduces the riding fatigue dramatically, thereby improving operating efficiency and enhancing your overall driving experience. 2、Versatility: The hydraulic clutch kit is versatile and designed to fit various makes and models of motorcycles, making it a go to solution for bike enthusiasts. 3、Durable Construction: Precision manufactured from stainless steel and plastic, the kit ensures high stability and strong durability, thereby promising a long life. 4、Adjustable Angle: The angle of the handle can be adjusted in six gears, allowing riders to find the most comfortable and functional position for them. 5、Easy Installation: The kit is easy to install and includes professional accessories to provide a safer driving experience. Whether you're a seasoned mechanic or a beginner, the installation process is simple and straightforward. Item Type: Hydraulic Brake Clutch Set Material: Stainless Steel; Plastic With power off switch (both left and right) Clutch Line Length: Approx. 100cm / 39.37in Horn handle six adjustable angles Handlebar Ring Diameter: Approx. 14mm / 0.55in (After Tightening ) Product not oiled Method: 1. Install the pump by disconnecting the original pull line and connecting the product. 2. Use the original car switch wiring to connect to the product's power-off switch. If unable to connect, continue to use the original car switch. 3. Thread the clutch lower pump belt line through the front of the car, away from the engine and exhaust pipe to prevent heat damage. Use existing lines to secure the clutch line. 4. After threading the line, fully extend the clutch lower pump lever (tighten or loosen the fixing screw if needed). 5. Secure the clutch lower pump, ensuring it has a certain range of movement. Use a nut to secure it in place. 6. Push the clutch arm forward by hand until it cannot move further (maintain this position during installation). The clutch arm must be able to connect with the rod, trim the rod if too long. 7. Push the clutch arm forward by hand until it cannot move any further. If the clutch arm cannot connect with the rod, use an extension screw and nut on the clutch lower pump rod. Repeat step 6. 1 x Brake Handle 1 x Clutch Cable 1 x Clutch Handle 1 x Clutch Lower Pump 1 x U Clip 1 x Extension Screw 1 x Long Nut 1 x Small Nut