Feature:1. Hall‑type current conversion, which can withstand 30 times the nominal input, prevents instantaneous high current access and burns out the internal components of the sensor. The measurement circuit is isolated from the incoming signal2. Isolate the detection signal and the output signal, effectively filter the noise in the signal, which will greatly improve the signal‑to‑noise ratio and signal stability of the product, and effectively enhance the product's anti‑interference ability3. The primary and secondary sides of the hole current transmitter are highly insulated and isolated, which bring high accuracy, small size, low power consumption, wide frequency response, and anti‑interference4. No insertion loss because of erforated input, fixed with standard guide rail and flat screws, easy to install5. Especially suitable for load current intelligent monitoring systems such as generators, motors, intelligent low‑voltage power distribution cabinets, air conditioners, fans, street lamps, power grid monitoring, motor signal monitoring, railway system signal monitoring industriesSpecification:Item Type: AC Current TransmitterMaterial: ABSPower Supply: DC24VInstallation Method: Standard rail + flat screw fixationProduct Use: Used to measure AC current, especially for power frequency 50Hz sine wave AC currentRated Current: AC0-100ARated Output: DC4-20mALoad Capacity: Voltage Output: 5mA; Current Output: 6VAccuracy: 0.5%Overload Capacity: 30 Times the nominal inputIsolation withstand Voltage: 3KV/50Hz, 1MinOffset Voltage: ≤10mVTemperature Drift: ≤500PPM/℃Linearity: 0.1%Frequency Bandwidth: 20-5KHzCurrent Consumption: <15mA+ output currentResponse Time: <200msWorking Temperature: -109℃~+70℃Storage Temperature: 25℃~85℃.Package List:1 x AC Current TransmitterNote:Please do not use 250ohm or 500ohm to connect 4‑20mA output version of the transmitter to get 0‑5V or 0‑10V, this is a completely wrong method, you cannot get 0‑5V or 0‑10V signal, and it will make transmit becomes overheated or damaged.