Item Type: Pneumatic Percussion Hammer Material: Aluminum Alloy Connection Method: Thread Air Inlet Thread Specification: 1/4in Exhaust Thread Specification: 1/4in Working Pressure: 0.3-0.7MPa Mobile Direction: One-Way Nominal Frequency: 1-60 Times/Minute Exciting Force: 5.5-220 Newton.M Maximum Operating Temperature: 150 Applicable Scenarios: Vibration Table, Filter Screen, Silo Emptying, Bulk Material Flushing and Compaction, Preventing Pipelines from Hanging Only on the Silo Wall, Driving Conveying Device and Unloading Trough Equipment Purposes: Using Compressed Air as Power, Instant Release , Push the Inner Hammer Head to Hit the Bottom, Transfer the Strong Impulse to the Wall, Effectively Break the Arch Formed by the Material, Loosen the Accumulated Material, and Achieve the Purpose of Glossy Dust Unloading1Low air consumption, low operating cost, good environmental protection and energy saving effect 2The aluminum alloy has high strength, wear resistance and impact resistance and the accurate base has been turned and corrected many times, and the carbon steel material is not easy to break 3Due to the large impact of the magnetic force, the powder falling effect is good. Simple structure so easy to disassemble 4Pneumatic percussion hammer's percussion interval can be adjusted, with reliable quality and low failure rate 5Suitable for dusty and humid environments, widely used in pesticides, medicine, chemicals, cement, dyes, pigments, food, electronics, electricity, building materials, minerals, environmental protection and other industries 1 xPneumatic Percussion Hammer 2 x Air Tube Connector 1 xString