Holybro M10 GPS Module with Compass LED Indicator Onboard Buzzer for Pix32 Pixhawk 1/2.4.6/2.4.8 Flight Controller RC Models OverviewThe M10 GPS uses multi-constellation GNSS powered by u-blox M10 series, a concurrent GNSS receiver which can receive and track multiple GNSS systems. Owing to the multi-band RF front-end architecture all four major GNSS constellations, GPS,Galileo, GLONASS and BeiDou can be received concurrently. It also comes with the IST8310 compass, tricolored LED indicator, buzzer, and a safety switch. There are 3 different connectors options for different purposes. This module ships with a baud rate of 115200 5Hz. The high-gain 25 x 25 mm patch antenna provides excellent performance and the omnidirectional antenna radiation pattern increases flexibility for device installation. It features active circuitry for the ceramic patch antenna, rechargeable backup battery for warm starts. Features · Newest Ublox 10th Gen GNSS · Fast & Accurate Positioning · High-gain 25*25*4mm antenna · IST8310 Compass · Internal Buzzer, Safety switch · Ultra Bright UI RGB LED Holybro M10 GPS Specification GNSS Receiver:Ublox M10 Number of Concurrent GNSS:Up to 4 GNSS,BeiDou,Galileo,GLONASS,GPS,QZSS Frequency Band:GPS L1,Galileo E1,GLONASS L1,BeiDou B1,SBAS L1,QZSS L1 Compass:IST8310 Output Protocol:UBX (U-blox),NMEA Accuracy:2.0m CEP Nav. Update Rate:Up to 25 Hz (single GNSS),Up to 10 Hz (4 concurrent GNSS) GNSS Augmentation System:EGNOS, GAGAN, MSAS and WAAS,QZSS: L1S Default Baud Rate:115200 Input Voltage:4.7-5.2V Port Type:JST-GH-10P Antenna:25 x 25 x 4 mm ceramic patch antenna Power consumption:Less than 200mA @ 5V Operating Temperature:-40~80℃ Dimension:φ50 x14.4 mm Weight:32g Cable Length:26cm (42cm cable purchase separately) Other: Tri-color LED Onboard Buzzer Safety Switch LNA MAX2659ELT+ RF Amplifier Rechargeable Farah capacitance Low noise 3.3V regulator Difference between the three cable options - Holybro M10 Standard GPS (JST GHR1.25mm 10pin cable): · This option is the most common, it is used on the This connector can be used on Pixhawk Standard Flight Controller 10pin “GPS Module”or "GPS1" input port. - Holybro M10 Secondary GPS (JST GHR1.25mm 6pin cable): · This connector can be used on Pixhawk Standard Flight Controller 6pin“UART & I2C”or "GPS2" input port as secondary GPS. This GPS is also compatible with the Cube Flight Controller GPS2 Port. - Holybro M10 GPS for Pix32 & Pixhawk1/2.4.6/2.4.8 (Molex1.25mm 6pin & 4pin &3pin cable): · These connectors are for "Switch", "GPS", and "I2C" input ports on the Pix32/Pixhawk1/Pixhawk 2.4.6/2.4.8 Package Includes: · 1x M10 GPS Module · 1x Fixed Carbon Fiber GPS mount